How to upgrade ET9000 via USB memory stick

[Johev]

Thanks! :-)
It was no problems! Installation worked fine! :-)
Did it late yesterday so I didn't look so deep into it; but at a glance look I couldn't find a editor for the bouquets in the web interface?
Is there any?
Thought the old web-interface-editor worked fine to sort the channels...

Thanks! :-)
It was no problems! Installation worked fine! :-)
Did it late yesterday so I didn't look so deep into it; but at a glance look I couldn't find a editor for the bouquets in the web interface?
Is there any?
Thought the old web-interface-editor worked fine to sort the channels...

Hi tony_westling or anyone else that has experience with flashing an Xtrend ET9200.

I have a very similar situation to the one you have replied to back in May. I am on the Vix 2.3 or 2.4 (can't remember and when checking in the menus there is no About option to see what image I am using at the moment).

I wanted to update my box, following the procedure that you have described above.

1) Formatted an usb to FAT32
2) Downloaded the latest bootloader (et9000-bootloader.zip from 2012-May-13)
3) used winrar to extract the content and copied the folder et9000 to the root of the USB stick)
4) I have inserted the USB stick with the folder into the front usb port and booted up the receiver
5) It does not say it detects anything, it just shows me a message "ET9X00", as it does not say bootloader I did not press OK, so after a while it boots normally to the old image

If I rename the folder et9x00 instead of the et9000 it says that it detected an image Vix 2.3 something, but because it is not an image I did not dare to flash it like this.

What should I do?

Should I press OK when I see the message ET9X00 and wait for it to flash or should I rename the folder to ET9X00 and flash it as if it was an image?

Many thanks for all your needed help

Update: So when no USB pen is in the receiver and I turn it on I get the ET9X00 message before I see booting. So my conclusion is with the folder named ET9000 it does not detect the bootloader folder. What does it mean? Am I on the latest bootloader already or should I rename the folder to ET9X00?

Update2: When renaming the booloader folder to ET9X00 and booting the receiver I get the message:
Found Vix Image 2.3 20110930, do you want to flash it? Should I go ahead or should it say bootloader detected?