Cross epg with open tv summaries all the same?

[Ibby]

Hi folks

Currently have cross epg set up with open tv on my vu+ duo. Have updated to Vix 3.0 the other day and since then programme summaries for each and every programme on the epg are the same? They all say the following: "a nostalgic look back in time featuring family archive footage. Real housewives of Beverley...a history of Britainhow the celts saved Britain"

It's been like this last fe days since I updated the firmware. Any ideas? Thanks

[punisher]

you might need to re-download the epg for Open TV

[Ibby]

Sorry for sounding a bit thick but how do I do this?

[stevesom]

Press blue button then crossepg downloader and away you go.

[Ibby]

Ah yeh have already tried doing that this morning the summaries are still the same!

[Mr. Mister]

To be honest.. I would do a complete flash again.. and set everything up from scratch..

That should cure it..

[punisher]

where is your epg stored?

[Ibby]

In my hard drive

[pooface]

My recommendation would be to telnet in to your box, and issue the following commands:

init 4
rm -r /media/hdd/crossepg
rm /media/hdd/epg.dat
init 3

This will completely remove all your epg data, and restart back in to e2. you will then have to redownload your epg data, but it shouldnt have any old data in there...

Sent from my iPad using Tapatalk HD

[Ibby]

By telnet does that mean FTP? I am sorry but I am still learning!!

[Stanman]

telnet is using some thing like windonws command and than telnet 192.168.1.9 or whatever your box IP is or using a dedicated programme like putty.

[pooface]

By telnet does that mean FTP? I am sorry but I am still learning!!

This explains how to enable telnet in windows:

http://www.world-of-satellite.com/sh...t-in-Windows-7

Or, you could use putty as stanman says...

[Ibby]

Many thanks will give it a go

[copex]

windows/start/run type cmd

in the command window type telnet {ipaddress of sat box}

windows seven telnet is not enabled by default if this is the case google "how to enable telnet windows seven"

or down load putty (google it)

[Larry-G]

windows/start/run type cmd

in the command window type telnet {ipaddress of sat box}

windows seven telnet is not enabled by default if this is the case google "how to enable telnet windows seven"

or down load putty (google it)

no need to google for a how to. there is a tutorial here.




How to enable the default Telnet client in Windows 7 - Click Here