Virgin Media Super Hub ...

[punisher]

lol in the future no idea when but the new firmware will allow you to use it as modem only, so you can switch off wireless capabilities, but those fixes i gave above are a workaround the connectivity issues

[silverfox0786]

lol in the future no idea when but the new firmware will allow you to use it as modem only, so you can switch off wireless capabilities, but those fixes i gave above are a workaround the connectivity issues

for me mate its not a bother i dont have virgin and untill its sorted wont be signing up

[satmanbasil]

lol in the future no idea when but the new firmware will allow you to use it as modem only, so you can switch off wireless capabilities, but those fixes i gave above are a workaround the connectivity issues

Hi mate

If you check out google there are already instructions on how to do this

this is what i found

How to use your own router with a Virgin media Hub/Superhub

So here's how.

1. Plug your router’s WAN port into any of the LAN ports on the Hub/Superhub.

2. Plug your PC into any Hub/Superhub LAN port and access the management page by entering 192.168.0.1 into your web browser.

3. Login to the Hub/Superhub the username/password details are on a sticker underneath or on the side of your hub.

4. On the LAN IP page examine the DHCP lease info; you should see your PC and the second router listed, make a note of the MAC address of the router and add it to the DHCP reservation section and give the second router an IP address of 192.168.0.10.

5. Now go to the DMZ host page on the Hub/Superhub and enter the same IP address of the second router (e.g. 192.168.0.10).

6. Turn off the Hub/Superhub wireless functionality and firewall as this will let your second router provide it instead.

7. Reboot the second router by powering it off wait at least 60 seconds before powering back on again.

8. Plug your PC into the second router, login to the second router and set the following :

In router’s WAN setup for "Does your Internet connection require a login" set to NO, (this may also be known as Internet Connection type - "Automatic Configuration - DHCP" as it varies from router to router) and then you should see the WAN or internet as 192.168.0.10.

Connect your wired devices to the second router reboot once more and you should be good to go.

While im here can you guys with superhub please confirm do you have in your vu network setup the ip for the two name servers which i checked are virgin media im asking as in my last config i just had the ip of the router with no name servers.

regards
satmanbasil