No lights on ethernet port (gigable box and router)

[steve14]

I can't connect the gigable box to my router. I have tested the ethernet cable with my computer to the router and the cable definitely works. No light comes up on my router and no lights come up on the gigable box either. Is the ethernet port on the gigablue box faulty or is there some setting to turn the ethernet port on the gigable box on?

[Sicilian]

Are you defo using a straight through cable? Does the router have DHCP enabled? Have you tried rebooting the Gigablue? To reboot, hold down power button on the remote, then select restart on screen.

[steve14]

Yes it's a straight through cable, it works when I connect it to my PC and to the router. Cable definitetly works.

Yes router has DHCP enabled. My PC is set to obtain IP automatically and it works. Also I had my friends dreambox attached to the router using the same cable and that worked.

I have tried rebooting the Router a few times.

When I do network test, I get the following results

Lan Adaptor
Lan Connection Green light

Local Network
Disconnected Red light

DHCP
Enabale Green light

IP Address
Unconfirmed Red Light

Name Server
Unconfirmed Red light

[steve14]

Sorry forgot to add that I have rebooted the Gigablue a few times also

[Sicilian]

Is the set to dhcp? Is it getting an IP address in network settings?

[steve14]

gigable is set to dhcp... no it's not getting an IP address.

I'm very good with computers (have been building them for over 10 years and setting up networks etc) When the light does not come on the router when you connect the ethernet cable it usually means the cable is broken or the network card is broken. There is no light on the router and I've check all ports on the router and they all work. There are no lights flashing underneath the ethernet cable on the gigablue either (the two little LED's right underneath all ethernet ports).

[Sicilian]

With the power cable connected and ethernet disconnected are the lights even dimly lit?

[basilyoung]

have you tried setting up the ip of the unit, manually?

[steve14]

Yes tried it manually also... didn't work

[steve14]

Should I ring up world-of-satellite and see what they say?

[Sicilian]

Have you flashed the image at all? Does it have team red image on it?

If so re-flash the Team Red image from here http://www.world-of-satellite.com/sh...-2012-HD800-SE

How to flash guide http://www.world-of-satellite.com/sh...Blue-HD-800-SE

To flash copy the files in the FINISH ONLY folder to the root of your USB stick, the follow the flashing guide above.

I just checked mine, with ethernet cable disconnected they lights are off, when connected the came on. Try re-flashing and report back.

[basilyoung]

I would be very surprised if the unit is faulty, its more likely a corrupt image

[steve14]

OK will do. It came with the latest Team red image on it, so I just left it.

Also thanks for the help

[Sicilian]

Make sure to are 100% using a straight thru cable and not a crossoever cable.

[steve14]

It is definitely a straight cable... it works with my PC to router.