Hello Guest, if you are reading this it means you have not registered yet. Please take a second, Click here to register, and in a few simple steps you will be able to enjoy our community and use our OpenViX support section.
Results 1 to 4 of 4

Thread: TV volume

  1. #1

    Title
    Member
    Join Date
    Mar 2016
    Posts
    80
    Thanks
    27
    Thanked 7 Times in 5 Posts

    TV volume

    Just got the mew box and I am stumped!

    I put the code in for my TV to control the volume and it was working fine.

    Now, I have to press TV on the remote to control the volume otherwise the box adjusts the volume?!

    Any ideas?

  2. #2
    thecaretaker's Avatar
    Title
    Forum Supporter
    Donated Member
    Join Date
    Apr 2012
    Location
    Southern UK
    Posts
    312
    Thanks
    136
    Thanked 136 Times in 77 Posts
    I don't know what box you have, but it sounds like you didn't complete the remote programming fully. Make sure you carry out the last step for the remote to remember the setting. On VU+ boxes you may need to click 'OK' or depending on the method you are using, you may need to Press OK and STOP for it to remember. Check the manual for your new box.
    VU+ Duo 4K SE

  3. #3

    Title
    Member
    Join Date
    Mar 2016
    Posts
    80
    Thanks
    27
    Thanked 7 Times in 5 Posts
    Thanks for the reply.

    It is the Gigablue UHD UE 4K. The setup was a bit of a palava as my TV, a Panasonic TX700B only has one code!

    I will have another read of the remote manual.

  4. #4
    Joe_90's Avatar
    Title
    Moderator
    Join Date
    Mar 2014
    Location
    Wicklow, Ireland
    Posts
    4,244
    Thanks
    1,315
    Thanked 1,148 Times in 908 Posts
    I presume you're referring to the GigaBlue remote? If so, the TV button on the remote needs to be pressed first if you are going to adjust the TV volume. If you press the Giga button, then the volume control adjusts the GB box volume. That's the way the remote works on my GB Quad Plus. I normally set the TV volume to (say) 20 and then leave it like that. I adjust the box volume as required. The only slight issue is if you are tuned to a channel transmitting Dolby Digital as the box volume is fixed over HDMI. In that case set the TV volume to suit the DD (or AAC) channels on HD and then adjust the box volume to suit the PCM channels (normally the SD channels).
    GB Quad Plus, Mut@nt HD51, AX HD61, 80cm dish and Supreme Dark motor. Sony TA-AN1000, Sony UBP-X800M2 Bluray, Odroid N2+ (CoreElec), Monitor Audio Bronze 5.1 speakers

  5. The Following User Says Thank You to Joe_90 For This Useful Post:

    gdmm (08-01-23)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
This website uses cookies
We use cookies to store session information to facilitate remembering your login information, to allow you to save website preferences, to personalise content and ads, to provide social media features and to analyse our traffic. We also share information about your use of our site with our social media, advertising and analytics partners.