Hello,
I have recently installed a Zgemma H9 combi with Openvix. My local transmitter is listed in ABM. There are 2 muxes. Ch 31 & 37. When I perform a scan, I only pick up the channels in one mux. I know I have signal for both muxes. I tried adding the muxes under signal finder, but this only works for one mux also. I can see both muxes in signal finder, I can scan both, but only get channels for one mux. I know this box works fine for a different Saorview transmitter with two muxes. Is it possible that the information in ABM is not correct for the mux in question. Kilduff, tipperary, Ireland, ch31 & ch37. Any help would be much appreciated.