Hi,
I recently set up my Ultimo4K from scratch as I was getting crashing issues every few days.
- System OE: OE-Alliance 4.3
- Firmware version: OpenViX 5.3.039 (2020-07-19)
- Kernel / Drivers: 3.14.28 / 20190424
- OWIF: 1.4.0
Unfortunately this did not help, I can still observe the memory reaching capacity via the top command every few days. It will then eventually crash. Prior to a fresh install I replaced the HDD.
The device is also used for development as I maintain the pvr.vuplus (Enigma2) add-on for kodi so there will be a lot of use via OpenWebIf, both for the XML APIs and streaming server.
I'm not sure exactly when this started but I could use some guidance on how to track down what causes this. Outside of occasionally manually updating OpenWebIf with fixes I would not know too much about the enigma2 internals. For all I know the memory usage pattern is expected and the issue lies somewhere else!
Thanks in advance for any help.
P.S.
I should add that the Ultimo4K has 2xDVB-S2 FBC tuners and a DUAL DVB-T2 tuner. It is configured via ABM for both Freesat and Saorview in Ireland. This is the only configuration applied since the fresh install. The saorview channels appear as part of the freesat bouquets using a custom mix file. All EPG data is embedded in the stream.