Amiko viper 4k , will not boot ,after uploading new image.
Amiko viper 4k , will not boot ,after uploading new image.
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
Please help keep OpenViX online, donate HERE.
Rules can be found HERE
Support our sponsor World-Of-Satellite HERE
GIGABLUE UHD QUAD 4K, VU+ DUO 4K SE, ZGEMMA H7S, VU+ UNO 4K SE
Triax 1.1m Powered by TM2600, Fixed 28.2 Zone 2 dish with GT-SAT Unicable
I've just made a fresh flash at latest available OpenViX at time of writing 5.3.019 on the Amiko Viper 4K albeit via multiboot and via existing booted image (couch flash) but no issues here, flashed fine, booted up, setup, no issues.
You should probably start over if you still have have the boot issue by downloading the firmware again HERE just to be sure and then following the USB flash guide HERE - This will most likely have you back up and running.
screenshot_20200401220437.jpg
Andy_Hazza (01-04-20),Sicilian (02-04-20)