No Splitters, 20mt run of original Sky twin shot cable
Tuner A Scan results below
Tuner A Single Sat Manual Scan.jpg
No Splitters, 20mt run of original Sky twin shot cable
Tuner A Scan results below
Tuner A Single Sat Manual Scan.jpg
That's the right number of services to find, so your dish alignment is fine although LNB ports are independent. However, you have swapped cables round so that rules out the LNB being faulty. lathough you do get odd weird switching faults. You could try at a friends house if you want to rule this out too. Make sure they don't have a Sky Q LNB.
Sorry to ask, but did you try the scan of tuner B with it disabled or enabled? And what have you configured it as? If tuner B is not finding services when enabled and correctly configured, best to speak to your seller.
Last edited by abu baniaz; 22-09-19 at 00:04.
Have 2 dishs running and getting same on both. Tested with a VU+Duo & zgemma H2 and working fine on both dishs.
Tuner B was enabled (Set to = Tuner A)
Looking like faulty B Tuner ?
Last edited by kiltoom; 22-09-19 at 00:17.
Looks like issue with tuner B. I prefer to manually set tuner instead of equal to.
Last edited by abu baniaz; 22-09-19 at 06:48.
Has tried both ways, Thanks for help