Zgemma H9S OpenVix Oscamymod 18-56

[lespat]

I have also been trying to sort out 27.5w on a Zgemma H7s using Openvix, but failing. A step by step guide would be useful as to how you did it on a arm receiver? Which oscam, keys, config, + anything else needed to know?

[twol]

I have also been trying to sort out 27.5w on a Zgemma H7s using Openvix, but failing. A step by step guide would be useful as to how you did it on a arm receiver? Which oscam, keys, config, + anything else needed to know?

All the main images now support access to this provider without the tricky code or fancy Oscam that was needed 7 years ago.

Without wanting to push another WEB site, as you probably know if you google 27.5W there is an extensive thread on this other Images forum that specifies in minute detail the requirements - and all you need is the patience to read the last 15 pages - not from the start in 2012!

Basically all you need is:

1. constant.cw
2. modded lamedb for 27.5W portion (see 4 below)
3. oscam.server with added BISS reader that uses the constant.cw
4. a standard Oscam emu, and simply add a BISS (cw) reader and a flag on lamedb file, C:2600

[reader]
label                         = BISS
protocol                      = constcw
device                        = /etc/tuxbox/config/constant.cw
caid                          = 2600
group                         = 1

constant.cw

2600:000000:1100:01F4:1FFF::XX XX XX XX XX XX XX XX XX XX XX XX XX XX XX XX ;BeeBeeCee N
2600:000000:1044:0064:1FFF::XX XX XX XX XX XX XX XX XX XX XX XX XX XX XX XX ;BeeBeeCee 1
....

there are full copies of the required constant.cw on other web sites.