Having just updated to 5.2.035 I’ve noticed that when my motorised dish moves from one position to another, I no longer get the positioned movement icon despite it being switched on in settings.
Maybe a possible bug?
Regards
Having just updated to 5.2.035 I’ve noticed that when my motorised dish moves from one position to another, I no longer get the positioned movement icon despite it being switched on in settings.
Maybe a possible bug?
Regards
same here on mutant hd51
micscave (12-04-19)
and Duo² also says tune fail while dish is still moving
micscave (12-04-19)
I have just changed my setting on Duo² to Not Flashing and it now works fine
micscave (12-04-19)
Same problem here on 5.2.038 with a Mutant HD51 when using USALS, the box reports tune failed without waiting for the disk to move.
I'm on a Stab HH120.
Actually I've been into tuner settings and adjusted the fine motor setting back to 0.1 and after saving moving seems to be working again with the positioner icon and countdown back - not sure if that would also sort your issue?
micscave (13-04-19)
rte (16-04-19)
Same problem. Error message only flashes before reaching the position.
Vu+Ultimo/D80cm 2LNB/OpenVix5.2.045ViXBMC1080Confluence/1xDVB-S2+1xDVB-C/T+1xDVB-C/T/T2 &
Vu+Ultimo4K/D80cm motor/OpenVix6.6.008ViXBMC1080Confluence/1xDVB-S2+1xDVB-C/T+1xDVB-C/T/T2
When you're in the tuner setup (the one which has the motor connected) go to Extra motor options and press right to toggle from No to Yes and the extra options will appear.
The speed and tuning step size can differ between motors so I have mine set according to the Stab motor.
It could be that maybe just changing any setting and saving could fix this potentially so worth a go - in my case it was just dropping the turning step size from 0.3 to 0.1 as per motor specs.
Now I finally got it. Being on satellite channel, pushing Menu, Setup, Tuner config, Positioner setup and then Menu gives the Extra motor options. I changed 0.360 to 0.100, rebooted and it really works. The Menu push after Positioner setup was not obvious. Thanks.
Vu+Ultimo/D80cm 2LNB/OpenVix5.2.045ViXBMC1080Confluence/1xDVB-S2+1xDVB-C/T+1xDVB-C/T/T2 &
Vu+Ultimo4K/D80cm motor/OpenVix6.6.008ViXBMC1080Confluence/1xDVB-S2+1xDVB-C/T+1xDVB-C/T/T2
micscave (21-04-19)