Hi
My technomate nano-2t goes to german screen, it reads the USB stick but i cannot update from it, any ideas? I have screen shot of german screen
Hi
My technomate nano-2t goes to german screen, it reads the USB stick but i cannot update from it, any ideas? I have screen shot of german screen
Last edited by gsc1ugs; 03-01-19 at 17:04.
9BAA3B73-64C2-40AD-95F4-4511D930E933.jpg
See the file uploaded
Do you know the ip address of the receiver? You can find it on from your router's config page.
I cant even boot the box into vix, it loads when i kept pressing menu button repeatedly but when i scan for channels it reboots, back to square one?
That was not the question being asked. What is the receivers IP address. Find it from router.
WAN IP address deleted by moderator
Last edited by abu baniaz; 03-01-19 at 18:27.
The IP address of the receiver. Not your WAN IP.
The Technomates have a LAN button on remote. That will get you into the Netwrok settings page, you can get the IP address of the receiver that way.
Once you have it, you can make changes using openwebif
Well, while im struggling get to that can you tell my why it reboots b4 channel search is completed please?
Ive fot the menu up, where do i find ip?
If you are struggling to press a button on your remote, how are you managing to do a scan?
Anyway, when you are ready, when you get the IP address, issue the following commands one at a time. This will install latest openatv (thanks to grog68). Make sure you select English. Do the scanning after you restart.
init 4
wget --no-check-certificate -O installatv.sh https://www.dropbox.com/s/nqbo698rxc...allatv.sh?dl=1 && bash installatv.sh
Guide to issuing commands in my signature
paste, do not type
Anyhow, i got to start a scan and a few channela came up then BOOM.... went off now stuck on booting...!!?
Sorry sound dumb, where and what device do i type those commands please?
abu baniaz (03-01-19)
I cant find it sorry, found your guide not aure what device