My Technomate Motor stops at 20 west. No limits set on the motor or in the image. I did a motor reset but still the same. I can move the motor west past 20 degrees with the motor buttons. New LNB fitted so is it the motor?
My Technomate Motor stops at 20 west. No limits set on the motor or in the image. I did a motor reset but still the same. I can move the motor west past 20 degrees with the motor buttons. New LNB fitted so is it the motor?
You mustn't have reset it properly. I presume you are using the buttons on the motor to reset it?
Zgemma H7S running OpenVIX 6.2, Darkmotor, Triax TD110 dish, Inverto Black Ultra dual lnb
LG 50UM7450 4K TV, Pioneer VSX-534 Atmos AVR , Panasonic UB820 region free 4K Bluray & a PS4.
You may have limits in the software but you may need to use disecq instead of usals to clear them. Once that is done you can switch back to USALS.
Last edited by ronand; 01-08-17 at 14:51.
Zgemma H7S running OpenVIX 6.2, Darkmotor, Triax TD110 dish, Inverto Black Ultra dual lnb
LG 50UM7450 4K TV, Pioneer VSX-534 Atmos AVR , Panasonic UB820 region free 4K Bluray & a PS4.
This is the 2nd one of these I have had with a similar problem. Think I will go for a Stab next time only a few quid more.