hi all, just got my tm800 and flashed no problem, ive inputted my cccam config but dont seem to be working, i have a tm600 and that works fine. i understand that the donfig goes into etc, cccam is not clearing any channels, please helpppp
hi all, just got my tm800 and flashed no problem, ive inputted my cccam config but dont seem to be working, i have a tm600 and that works fine. i understand that the donfig goes into etc, cccam is not clearing any channels, please helpppp
Have you installed cccam mate?
Vu+ Duo & 1TB Samsung EcoGreen HDD, TM-2600 Motor, Fracarro Penta 85, Inverto Black Ultra Twin LNB
yes, the image has cccam 2.2.1 installed, i copied over my config, but no joy. i dont understand where im going wrong?
recheck the actual config file and make sure its correct
and that cccam is actually started
PM HELP WILL BE IGNORED PLEASE POST HERE IN FORUM AS IT BENEFITS EVERYONE
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN! IN OPEN FORUM OR PM
IF THE POSTS HELP PLEASE CLICK THANKS OR ADD TO REP ↓
does it not go into var/etc in your TM 800 box..... ??
What else can i say !!.....
You can`t please all of the people all of the time...so...dont even try........ ...
Code:http://www.youtube.com/watch?v=dugJTYz-JR4&feature=em-subs_digest
i have put my config into etc and not var/etc. i have downloaded cccam info and it shows my config file but all clients and servers are off line. plug my tm600 in and thats working no problem, so it cant be my internet connection, puzzled !!!!!!!!!!!
your CCcam.cfg file goes into /etc
is your TM800 connecting to the external internet? press the LAN button, and at the bottom of the screen, where it says link, it should have a green dot, wait for it to say connected above it, and see if your external IP appears in the panel on the left, takes ~ 20 seconds
this will ensure that you are actually connected to the net
Sicilian (22-01-11)
restart the network wizard, ensure DHCP is enabled
your receiver knows its connected to 'something' but it cannot connect outside of your router
all sorted. it was a router problem not a cccam problem, thanks for your help.
Excellent, glad your sorted
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
Please help keep OpenViX online, donate HERE.
Rules can be found HERE
Support our sponsor World-Of-Satellite HERE
GIGABLUE UHD QUAD 4K, VU+ DUO 4K SE, ZGEMMA H7S, VU+ UNO 4K SE
Triax 1.1m Powered by TM2600, Fixed 28.2 Zone 2 dish with GT-SAT Unicable