Hi to anyone whom needs to input your MAC address back into your box, I have re-written the instructions because the one`s that technomate provide are very vague so follow what I have put below and you will find it a doddle
HOW TO DO IT
Even if the instructions are followed in some circumstances it will not write.
By following below instruction job done each time by 100%
Ignore TM-Nnao writing on the Loader it is for all 7355 models
1-Look at the bottom of your Receiver you will see Mac, Address
Write mac. address of any 7355 receiver on a sheet of paper >>I.e.>TM-twin/2t/nano/nano2t/single.
2-Read from right to left 12 digits Example. 1112 0cc6ac009c3f Use all7335 models Loader
3-connect RS232 to pc or Laptop
4-Go to device manager and check Ports (COM & LPT) Go to advanced and check what COM your USB or cable is on
5-Now turn off your receiver and connect the RS232 9 pin NULL MODEM cable to your receiver
6-Now turn back on your receiver and open up the MAC fixer and input your MAC address from the bottom
of your receiver, into the boxes 2 figures at a time and from the drop down menu choose the COM port
that your cable is on press start, you should now see your inputted
MAC address appear in the large grey box. when you see this re-boot your receiver
7-Whilst the receiver is re-booting immediately press ALT/C several times on your pc keyboard until you see
lot`s of figures appearing in the big box and finishes with CFE on the bottom of your screen /job is done
8-ALT/F4 will turn off the Loader off desktop screen.
PLEASE REMEMBER A NULL MODEM CROSSOVER TYPE CABLE IS REQUIRED TO COMPLETE THIS TASK