My gigablue quad plus has suddenly started to freeze and the spinners
then appear on screen and I am unable to use the box
here is my log file hope somebody can help
thanks
Enigma2_debug_2017-01-14_00-16-59.log
My gigablue quad plus has suddenly started to freeze and the spinners
then appear on screen and I am unable to use the box
here is my log file hope somebody can help
thanks
Enigma2_debug_2017-01-14_00-16-59.log
It looks like you're storing epg.dat to flash memory, which is not a good idea.
should be going to my hard drive, will have to check that out
thanks
2017-01-16.jpg
could this be the problem?
This is the issue:
The flash is full. Normally that would require a flash, but maybe you can save your system by simply deleting the file '/etc/enigma2/epg.dat'Code:<151107.868> [eEPGCache] store epg to realpath '/etc/enigma2/epg.dat' <151107.868> [eEPGCache] not enough free space at 'hàrhàrP–árP–ár.dat' 352604160 bytes available but 429487972 needed
If that works, set EPG to be saved to any local device xmt flash (HDD or USB).
Anyway: now you've learned the hard way why we advise not to store epg in flash
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
Well that is the strange thing I have always had my EPG saved to my HHD this only started after
updating to the latest firmware, still getting the spinners and frozen screen when I reboot
also now having problems with my tuners
Enigma2_debug_2017-01-16_10-53-37.log
Last edited by degogarn; 16-01-17 at 11:16.
Maybe filling up flash memory has corrupted a file?
I'd go back to an earlier image (or settings backup), make sure the epg is being saved to hdd, do a settings backup, and then re-flash the latest image and do a settings restore.
If you take image backups, that is the easiest way to go back a few days to restore a working system (epg apart).
Last edited by ccs; 16-01-17 at 11:54.
I have done a fresh install, everything was working fine until I reconnected my internet again
and load backup setting
Do you have port forwarding to the box set up on your router?
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
ok thanks that problem is now sorted with a fresh install,
but now getting a no free tuner error
Then it looks like your tuner configuration is incorrect.
Please tell us your LNB hardware setup and show us a screenshot of your tuner configuration.
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
ok seems my problems returned, after installing cccam
and went away again after removing cccam and installing oscam
never had this problem with the older firmware.
The tuner issue is after starting the box from standby if i restart
the tuners work fine until I put the box in standby