Fancy seeing you here!
I'll check it out, thanks . So will the switch in the link operate as I described?
Sent from my K6000 Pro using Tapatalk
Fancy seeing you here!
I'll check it out, thanks . So will the switch in the link operate as I described?
Sent from my K6000 Pro using Tapatalk
As I have a motorised set up then FBC tuner with standard Universal LNB and single cable from tuner to Lnb and motor should work - yes?
And I assume if I had a VU+UNO 4K it will allow dual recording or watch one and record one ? And what are the viewing restrictions Mentioned?
The fbc tunners come with the 4k boxes and run only OSCAM but not ccam, so what the work around that?
Last edited by Rob van der Does; 07-12-16 at 05:19. Reason: Typo
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
So would you be able to indicate what I'd need to connect to each connection..
865109_SUS_5581_33_NF_LEGACY.jpg
It would be simpler to use the plain SUS 5581 F model. This accepts a set of quattro LNB inputs on the top side (plus a terrestrial antenna feed if required) and outputs them all on the bottom side for forwarding to other equipment. The other connections are the Unicable output (with eight RF channels), an earth connection and a power connection, though the power connection is not required if LNB volts are being fed through from another device downstream -- in my picture, from a multiswitch via the white cables. Connection details and Unicable frequencies are clearly marked on the label.
20160911_101243s.jpg
When you say quattro inputs does that go for quad as well if the standard F model is switchable too?
Sent from my K6000 Pro using Tapatalk
Quattro is not quad.
A quattro LNB has 4 outputs; one for each 'quadrant. This means the (unicable) switch can output every single transponder to the receivers, independent of each other. In fact there are 4 LNB's inside, each fixed to one 'quadrant'.
A quad LNB has 4 outputs, each serving just one tuner. In fact there are 4 independant universal LNB's in one house.
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
Thanks Rob. Understand that but the Spaun switch referred to by twol is capable of using both quad and quattro.
Sent from my K6000 Pro using Tapatalk
Because for a quad, a switch setting sends a 22khtz signal to 2 of the ports to force high band , so effectively it becomes a quattro with vh,vl,hh,hl ports ..... my emp centauri multiswitch does the same which is kind of useful as I currently have a quad on my 28.2E dish (the previous quattro lnb kind of burnt out in our very hot 2015 summer 30+C - and I had a spare quad)
Gigablue Quad 4K & UE 4K
.........FBC Tuners:
------------------> GT-Sat unicable LNB to 1.5M dish(28.2E)
------------------> Gigablue unicable LNB to 80 cm dish(19.2E)
.......................> FBC & DVB-S2X into 90cm dish (27.5W) Opticum robust Unicable LNB
AX HD61, Edision Osmio 4K+, Zgemma H9Combo, Octagon SF8008 , gbtrio4k, h9se using unicable ports
Zgemma H9 C/S into Giga4K
Incorrect information deleted
Last edited by abu baniaz; 11-12-16 at 21:14.
twol (11-12-16)
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
Please post a screenshot of the settings to use.
I have no FBC tuners.
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
Incorrect information deleted
Last edited by abu baniaz; 11-12-16 at 21:14.
I have another question,
There are not a lot of reviews on VU+UNO 4K, what are the pros and cons between solo 4k and this model, is it just the extra tuner and display screen?
As it has a FBC tunner, what will be the viewing or sat channels restrictions when scanning as some have mentioned something about bandwidths which can cause limitations of somekind?
As it has 1 x Twin FBC S2 tunner will the UNIO 4K allow me to dual record or record 1 and watch one with single cable, lnb and motor as mentioned before?
I really need to have a clear understanding on above before buying as I found out that all 4K receiver are FBC tuners that you can not use motors.