I'll check again when I get home but the only thing that was showing up for mounting or initialize was the usb stick.
When I pulled the usb & rebooted , no devices showed.
I'll check again when I get home but the only thing that was showing up for mounting or initialize was the usb stick.
When I pulled the usb & rebooted , no devices showed.
Nearly forgot, I installed an HDD in a new E8000 and it had screws for a 3.5 inch hard drive but not for a 2.5, I had to scratch about for some.
VU+ Ultimo 4K 3TB, 1x Twin DVBS-2 FBC / 1x DVB-C FBC/ 1x Twin DVB-T2.
VU+ Solo4k 2TB, 2xFBC-S2, 2xC/T2, 1x Sundtek .
1m Motorised Single LNB Dish, 60cm Fixed Octo LNB Dish.
Samsung 65HU8500 with SEK-3500, Denon AVR-X2200W 5.1.2.
Oppo UDP-203
Panasonic 55VT50.
Zidoo X9S
Amazon Fire TV 4k & Amazon Fire TV (SPMC sideloaded).
Last edited by Huevos; 14-01-16 at 17:24.
Disk isn't starting. Just had a look & the plug on the supplied cable doesn't really fit properly into the connector on the pcb. Can't see anywhere else on the pcb for it to go so I'll have to bodge it or get in touch with WOS.
Are you plugging it in the right socket? Can yo post a picture please?
Picture attached. Hope thats clear
IMAG0106.jpg
abu baniaz (14-01-16)
Is that the right location & does the little solid triangle define the side where the red wire is?
Like I said I installed one of these last week and it isn't immediately obvious which way round the plug goes on as there are no notches, you could in my opinion force the plug on the wrong way way round if you wasn't paying attention.
VU+ Ultimo 4K 3TB, 1x Twin DVBS-2 FBC / 1x DVB-C FBC/ 1x Twin DVB-T2.
VU+ Solo4k 2TB, 2xFBC-S2, 2xC/T2, 1x Sundtek .
1m Motorised Single LNB Dish, 60cm Fixed Octo LNB Dish.
Samsung 65HU8500 with SEK-3500, Denon AVR-X2200W 5.1.2.
Oppo UDP-203
Panasonic 55VT50.
Zidoo X9S
Amazon Fire TV 4k & Amazon Fire TV (SPMC sideloaded).
there is a notch...if you look closely it matches up, on the motherboard at the bottom you will see a grove match this up with the lug
mines all wired up, but I did find this for you
paul1098 (14-01-16)
That looks like you have the correct plug. I've had a look at other plugs on the mboard with the same latch arrangement & they look like yours. My power plug is different to that.
The red & yellow wires are in the same place.
can you post a picture of the end of your power lead plug
Best photo I could manage.
IMAG0107.jpg
I cant see it very well..
the picture I posted is the same as mine