Done.
Also uploaded new bootloaders for the ET8k & 10k (allowing images up to 200MB to be flashed).
Done.
Also uploaded new bootloaders for the ET8k & 10k (allowing images up to 200MB to be flashed).
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
abu baniaz (24-08-14),judge (24-08-14),mcquaim (24-08-14),Mr. Mister (24-08-14)
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
Should not have been an issue Rob.. As build 025 requires a full fresh flash.. with no backups allowed..
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
Flashed the se plus with 025 no probs
GB Quad Plus, Mut@nt HD51, AX HD61, 80cm dish and Supreme Dark motor. Sony STR-DN 1060, Sony UHP-H1 Bluray, Odroid N2+ (CoreElec), Monitor Audio Bronze 5.1 speakers
No i did not just flashed it going to load softcam and cccam.cfg. Have not got hard drive connected trying to share hard drive on my pc.Says its there in the mount manager but cannot view files will get there .
Just flashed my GB Quad (not Plus) with bootloaders from the OpenVix site and now my box won't boot! Gets as far as spinning the HDD but then it spins down and the box shows a red LED on the front panel but goes no further. If I stick the USB stick in the rear USB port and power-cycle the box it recognises that an image needs flashing and prompts me to OK it again... :-(
Helllllp / suggestions PLEASE!
Cheers,
Steve
Flash the bootloader again then power down and flash the image. But make sure you use the correct bootloader for your receiver.
Sent from my SM-G900F using Tapatalk
My posts contain my own personal thoughts and opinions, they do not represent those of any organisation or group but my own.
If you don't like what I post, Don't read it.
SIMPLES.
Yes - I flashed the bootloader the same as I would for a normal flash. Then powered off the box and flashed the new image.
GB Quad Plus, Mut@nt HD51, AX HD61, 80cm dish and Supreme Dark motor. Sony STR-DN 1060, Sony UHP-H1 Bluray, Odroid N2+ (CoreElec), Monitor Audio Bronze 5.1 speakers
OK, When I try that, the box does not come back with a message to press the power button or the OK button as a new flash would do. It reads the USB stick but does nothing? Shall I try a 025 flash first?
Tried a 025 flash and when the warning triangle disappears that all that remains is the Gigablue logo and nothing else happens?
Last edited by madaboutlotus; 30-08-14 at 19:04. Reason: More info