I some how have lost all my satellites and cant get my box to retune anyone help
I some how have lost all my satellites and cant get my box to retune anyone help
Hm, same category as 'help please, my car doesn't work'.....
Please consider providing some information, such as which image you use, what your tuner setup is and how you set up services.
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
all I can tell u is that is that its a technomate tm-nane-oe and its got e2v3.1.o
it does nt show any off the satellites just co ordinates and when u press on one of them the channels are grey out like they re not there
You are sitting in front of the reciver, we are not. So take it easy and explain thoroughly and hopefully you can sort your issue.
1. What image have you got. Press Menu> information > About and post all details.
2. What is your dish setup in trems of physically.
3. What is the tuner configuartion? Menu > Setup> Service searching
4.Did you upload a channel list, if so which one?
hardware tm-nano-oe
mac address Deleted mac address
milcom version :112
image penpli 3.0
kernel version :3.5.3
enigma :12-05-13
tuner a:bcm7335(internal) dvb-52
motorised dish
channel list -vhannimal e2 motor
Last edited by abu baniaz; 27-05-14 at 20:39. Reason: deleted mac address
I have edited your post and deletd your mac address.
Can you answer question 3. Press
Menu > Setup> Service searching > Tuner configuration.
And please be aware that PLi-vs 3 is now very old and no longer supported.
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
config-simple
mode-diseqc a/b
port a - nothing connected
port b - nothing connected
set voltage and 22khz-yes
send diseqc on sat change -yes
Your tuner config is incorrect. You have told your receiver that you are using a diseqc switch.
Your setup should be like this:
If you wish to download a newer 4D image, you can download from
Code:http://download.for-better.biz/bbs/list.php?board=tmnanooe
set it up like u said ,when I reboot it say check tuner config ,no service
Did you replace the coordiantes with your ones? Also, when you changed the configs last time, did you say yes to "delete all unconfigured satellites"