I have solved the problem now, i had to RESET the Satseeker positioner, now it moves small steps as it should.
I have an existing motorised set up, Manhattan ST500 receiver with built in 36v positioner, Jaeger Gold motor and 88cm dish. I am wanting to add a VU+ to this setup using the Manhattan positioner to move the dish and lnb loopthrough to the VU+. It is a single lnb setup. As I now sit down and think of how this would work in practice I am starting to have doubts about it's practicality. Has anyone else got a similar setup that could help me out? Thanks in advance.
The VU+ duly arrived and I used lnb loopthrough from the Manhattan and it worked but only if the Manhattan was subsequently switched off. I thought about a priority switch but instead went for a Gbox V2000 positioner unit. The Gbox and Vu+ work well together but there is a significant (particularly with the current weather) signal loss to the extent that some weaker transmissions have disappeared (they reappear if I reconnect to the Manhattan). I am not yet able to connect to a network (awaiting wireless dongle) when the VU+ will hopefully give the Manhattan a clean pair of heels but I am initially a little disappointed by the signal loss and the fact that it is a little buggy (I am currently using VTI image having tried original, PLi and Vix) all have suffered with green screen message shutdown/restart or blank screen even on fta German Hot Bird channels.
If you are receiving channels better on the Manhattan than the Vu there is a bad connection somewhere. Vu tuner is unbeatable. Also since I switch to VIX 1.3 I haven't had one green screen. Trouble probably is because you are not connected to the network, as the first thing you are supposed to do after installing the image is download the latest updates as these don't contain known green screen bugs.
Last edited by Huevos; 29-12-10 at 14:39.
Hi
I am using Vix 3.0 on my Vu + duo and currently have the following satellites in the box
1 West Thor
Sirius 4.8
7 east Eutelsate
9 East Eutelsat
13east Hotbird
16east Eutelsat
19.2 e Astra
23.5 Astra
28 Astra
But for some reason will not let me add 10east so I can move the dish to this position and then store the satellite
Any ideas
Bit of a novice but done ok so far