AV Setting Problem Since Reflashing to 760

[baz135]

My system is a Vu+solo2 connected via HDMI to a Samsung TV model number LE32R88BD

Since updating using USB to flash to V760 I have the following problem with the AV Settings.

1. After re-start AV Setting shows Video Output = Scart, even though NO scart lead is connected only a HDMI cable.
2. I have tried to changing setting to HDMI. My TV screen goes blank and get message “Output Not Supported. I get the same result when I try all the other Output settings including going back to Scart.
3. The only way I can get AV output (picture on TV) is to re-flash image, I then get Video Output showing as Scart even though it is only connect to TV via HDMI cable.

I have tried all the other versions from 761 to 763, and change HMDI cable all without success. I have now gone back to version 753 which works OK.

Any help would be appreciated, thanks.

[gordyboy]

seems there are a number of us with this issue

[s1m0nw]

I have to admit It was scart for me after I had already selected hdmi during setup but once i changed it again in av settings its been fine. am on 763.