Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
Turn on unstable updates.
haude (18-08-13)
Sorry on latest 721 still the same as before last two saying unconfirmed
Still not working for me either, I'm also on 721 Router is a NetgearDGN2000 -
Looks like it can see the router and even connect (not 100$ sure on this) however it can't get IP and also nameserver also fails.
Last edited by zoro25; 21-08-13 at 23:38.
I've been a bit busy last few days, is anyone able to do a fresh flash of 722, no backup restore, test wifi with DHCP on and report back please?
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
Please help keep OpenViX online, donate HERE.
Rules can be found HERE
Support our sponsor World-Of-Satellite HERE
GIGABLUE UHD QUAD 4K, VU+ DUO 4K SE, ZGEMMA H7S, VU+ UNO 4K SE
Triax 1.1m Powered by TM2600, Fixed 28.2 Zone 2 dish with GT-SAT Unicable
flashed 722 DHCP on no restore wifi still failing
Last edited by s1m0nw; 22-08-13 at 10:46.
Vu+ Duo
Vu+ Solo
Gigablue HD 800 SE
All with latest vix image - Autobouquets - SgtFlipflop 28.2e Picons - WebradioFS
I had WiFi working fine but then started getting isues with DCC saying about Error 10037. Have the IP addresses of devices set correctly, tried static and dynamic. Will try again later, might need to reflash it perhaps.
I'm using Bt home hub set at automatic tried 1,6,11 still failing
still don't understand why built in WiFi doesn't work on my set upon vix. so switch to blackhole and it set through the wizard no problem its very hard to know reason why?
mine is the same,
only wep and disabled protection works on mine.
All WPA encryptions do not work :-( and have not since getting box.
My next thing to try is to swap the router at home with a spare I have.
It's a shame because I prefer vix user friendly image, I still use it with the duo. For the duo2 wifi works on the BH image leads me to believe that it a driver issue between vix and my router. Zoro25 please reply if changing your router sets the wifi. Also for security reason I wouldn't use wep or go unencrypted.
Ok got mine working,
Funny thing was I did nothing different, except flash new image without using a backup. But of a pain but not big shakes, I now have WIFI with WPA-2 working on the DUO2 :-)
parma (23-10-13)
what build did you use