Got the driver, anybody able to tell me how do I manually update my box with these drivers, cheers
Got the driver, anybody able to tell me how do I manually update my box with these drivers, cheers
This is the worst driver in my opinion although it records the picture is shaky and stutters every now and again then goes back to normal. Even when you are not recording the same thing happens when watching the channel in real time, one of the channels badly affected was channel 5 HD.
I've downgraded my drivers to early April and all recordings have been fine since. The only problem is with two timer recording at the same time where one will not record at all but I've manged to get round that for now by setting one of the timers to start a minute later than the other.
cheers mkhan, how do you manually load them?
scottmcroberts (01-07-13)
muchos grazias sir, will give it a bash just now
Did that rebooted, went into information and it still comes up drivers from last vix update 03 06 2013. Checked the the folder and it is definitely in the...../extra file
I presume it should install automatically or do I need to do something else
Driver details are hard coded into the image. They will not change when you manually use drivers other than the ones in the image itself. Your drivers most likely updated.
Tapatalker
scottmcroberts (01-07-13)
sweet cheers guys
Richard of TM says that 20130614 is the best one so far. He has not tested 20130701 properly yet.
EDIT:
Looks like the 20130614 will be in the openaaf image soon.
https://github.com/oe-alliance/oe-al...501f24317cec32
Last edited by abu baniaz; 01-07-13 at 23:17.
Brilliant will change it to the one above, Thank goodness for the good people on WOS, cheers folks
I doubt the drivers are hard coded into the image if that were the case the old drivers I manually added to the latest image would not have any affect. The old drivers for me are a lot better than the later ones just the two timer recording is a issue where you have to set one program to record a minute later than the other. However no recordings have failed for me.
Last edited by mkhan; 03-07-13 at 15:40.
Drivers are not hard coded. Just their details - if you access the information menu.
Tapatalker
When you power on a TM-OE receiver, it will dispaly the drivers date in the VFD.
The date in the about> info section of the image displays the date of the drivers that were included in the image when it was built, this data will not change until a new set of drivers is included in a later build.
The image has no way of knowing the driver date unless we tell it this info when it is being built.
Sent from my GT-I9300 using Tapatalk 2
My posts contain my own personal thoughts and opinions, they do not represent those of any organisation or group but my own.
If you don't like what I post, Don't read it.
SIMPLES.
abu baniaz (03-07-13),mkhan (03-07-13),scottmcroberts (04-07-13)