Tryed set motorised dish up failed got expert in ,he set dish up to hotbird 13e scanned got 72 services only a few work ,dont seem to be able to find any other sats ,am i doing something wrong
Goto Menu, Setup > Service Searching > Manual scan, then set as follows: - (use left, right buttons to change the fields)
Tuner = Tuner where motor dish is connected to.
Type of Scan = Single Satellite
System = DVB-S
Satellite = Hotbird 13deg
Leave others as default but change network scan to yes.
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
Please help keep OpenViX online, donate HERE.
Rules can be found HERE
Support our sponsor World-Of-Satellite HERE
GIGABLUE UHD QUAD 4K, VU+ DUO 4K SE, ZGEMMA H7S, VU+ UNO 4K SE
Triax 1.1m Powered by TM2600, Fixed 28.2 Zone 2 dish with GT-SAT Unicable
thanks for that tried it again still only get 72 ,put 53.72n lat 1.35w lon for my area ,set motor to zero chose a program for hotbird rotates there get 72 tried program for astra just keeps flashing up rotating i must have something wrong could dish still be wrong
There are many ways your dish could be out.
I'm no expert, but I would say the best way to start alignment is to start at Thor 1w.
This is the top of your arc, and closest to zero, well it is for me.
If mount is 100% plumb, and both dish and motor are at correct settings, once you tune 1w, all other sats fall into place.
If you can only pull in 13e, and east or west detects no other sats, then you must re align your dish.
Sicilian (11-05-10)
will get back in touch with him who set it up thanks for your help
Posting Permissions
Reply With Quote
