Updated to Vix 658 the other day and after that the display looked as in the attached image.
I've reverted to 656, but the display is still not working.
Anybody have a clue what to do?
20130511_114543.jpg
Updated to Vix 658 the other day and after that the display looked as in the attached image.
I've reverted to 656, but the display is still not working.
Anybody have a clue what to do?
20130511_114543.jpg
Looks like a hardware failure?
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
Hi I updated yesterday and although my display is ok now when the box rebooted the display screen flickered for about 10 seconds which showed numbers 442. Been ok since though, maybe a problem with software update..
Vix image (usually latest) - VU Solo 4K- WD 1TB INTERNAL HDD - DVB-T Freeview, trialling IPTV options
If my response has helped you, don't forget to hit the thanks button below. I appreciate you appreciate me
Have you tried turning the box off with the switch on the back and then back on?
Mine has often done that before after doing a software update, turning it physically off and back on fixes it.
Update to the latest build and you should be fine.
Support The Sponsor - Buy from the best HERE
Please abide by the rules - have a read HERE
VIX manual & guides >>HERE
Download images from >> HERE
New Box Setup Guide >>HERE
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
PM HELP WILL BE IGNORED PLEASE POST HERE IN FORUM AS IT BENEFITS EVERYONE
Follow us on Twitter
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN! IN OPEN FORUM OR PM
IF THE POSTS HELP PLEASE CLICK THANKS OR ADD TO REP ?
There was an issue with build 656 where the ultimo (and a few other boxes I think), had vfd problems with it flickering like in your picture... This was cleared with later updates. However, as mentioned, may need a full power down to clear the issue...
Using the power switch on the back did it. The display is fine.
Thanks everybody.