iam pretty sure my own 2mt2 does not suffer from this.
iam pretty sure my own 2mt2 does not suffer from this.
Don't know if this is the proper way of doing things. I normally save the epg to HDD after downloading it.
Menu > System > EPG > Load/Save > Save epg
This saves the cached epg to the hdd so that on reboot it loads it. I have aslo enabled Download on tune in the cross epg setup section.
My posts contain my own personal thoughts and opinions, they do not represent those of any organisation or group but my own.
If you don't like what I post, Don't read it.
SIMPLES.
Deep standby then power down from the mains should suffice.
My posts contain my own personal thoughts and opinions, they do not represent those of any organisation or group but my own.
If you don't like what I post, Don't read it.
SIMPLES.
VU+ DUO² (Triple S2 tuners) VIX, 750gb
TM-Nano 2 Super, 320gb
GigaBlue HD 800 UE Plus VIX
TM-Single VIX IT'S ALIVE
Octagon SF8 VIX (751MHz bootloader)
MARA M9
Harmony 700
DGS108 GBLAN, DIY NAS (8TB) XPEnology
1.1m dish, 0.1db Quad LNB, GTSAT DM14MG motor
80cm dish, 2x 0.1db LNB + 1x Quad 0.2db LNB, Disqec 4/1.
I alway shut down my Tm Single down properly by pressing the power button on the remote control, it still wont save the EPG
I have the EPG stored in /media/usb
Exact same configuration on my Solo and Duo but they save/load the EPG fine