TM Single - Flashing Green/Red Light

[kman999]

Hi All,

I was wondering if anyone has seen this issue, loaded a TM Single with a VIX and 4D Image. After a few days popped the box back on and the the tm now shows flashing green/red light. Nothing on the screen. Did try loading the 4D Image back on but the same

Many Thanks

[kman999]

Hi All,

I was wondering if anyone has seen this issue, loaded a TM Single with a VIX and 4D Image. After a few days popped the box back on and the the tm now shows flashing green/red light. Nothing on the screen. Did try loading the 4D Image back on but the same

Many Thanks

Also the Logo comes up, then a blank screen after this the light are flashing green/red/green/red... .

I have followed the instruction on how to flash and tried both images again but still same. There is no hard disk fitted in the box

[Sicilian]

Are you pressing Exit button repeatedly on reboot?

[kman999]

Thank for your reply, yes I have done for 10 secs repeatdly still no luck.

[ssmacc]

I Know its not much help, but I have the box and have had no issues, it does sometimes flash red / green when booting, but has (so far!) always booted.

[abu baniaz]

Does it boot into the non-E2 mode? Press MENU on receiver when powering up.

[doxe]

I had the same issue. Just got the logo at the very start and nothing else. Disconnect everything and only have the power and HDMI connected and that worked for me.

Hope it sorts it for you

DoXe

[kman999]

thank you all for your help. for my issue it turned out to be my tv, i had a thought and connected it via scart and the box started no issues. I have changed some settings on my tv and it look ok now, thank you again