Hi guys,

After 8 years my Dark Motor gave up the goose the other day so i bought a new TM2600m3 from WOS.

i was hoping it would be an easy swap over, but unfortunately the dish angles different on the two motors - on the dark motor it was 27.5 and it's 5 degree different on the TM2600 making it 22.5. I had it set closer to 30 previously to be honest as it was as far as it would go - unfortunately it's still as far as it will go as the bracket on the dish at the top is pushed up against the motor bracket and without cutting a large chunk away (which i'd already done for the previous motor) it would tilt back to 22.5 degrees.

Presumably there's no way around this and i'm going to have to cut up the bracket a bit more? I'm just a bit worried about how rigid it'll be at the end of it.