Hi all ,

I am setting up a motorised dish on a vu+ solo 2 receiver. After a few teething problems which i have now rectified i can now drive the dish to the given sat by gotox.

My question is this do you think it is possible to receive reception from thor 0.8w using 60cm dish.

My current setup is this:
VU+ solo 2 Receiver
Technomate tm2600 motor
60cm dish with octo lnb

The dish is mounted high on the gable end of a south facing wall.
I have aligned the dish to true south with the motor on 0.
I THEN DROVE THE MOTOR TO THOR 0.8w
i used sat finder to adjust the dish via the motor bracketary.
I then inline connected a sat signal finder to fine adjust the signal however I could not get any feedback on the signal finder no matter how much i manipulated the dish around that satellite area.

I tried to setup to thor as people suggest this is best due to the highest sat but is it possible i cannot recieve this on a 60cm dish.

I will try to drive to astra 28.2 tonight and see if i have any luck.

but any feedback welcome.

regards jon.