Hi there,
I am trying to config the VU Solo2 box for receiving Satellite channels. I have one Satellite feed that I have connected to LNB1 input on the box. Under the Tuner set up in the Openvix 6 3 007 Release what do I need to select?
Thanks
Hi there,
I am trying to config the VU Solo2 box for receiving Satellite channels. I have one Satellite feed that I have connected to LNB1 input on the box. Under the Tuner set up in the Openvix 6 3 007 Release what do I need to select?
Thanks
You will need to select Tuner A to Simple , Mode Single.
Tuner B disable as no feed.
Assuming you are looking at 28.2
abu baniaz (06-04-23)
For tuner config to be correct, it must match the dish/lnb hooked up to it. You have not described what satellite your dish is pointed to or what the LNB type is. That being said, for most people in the UK, it is a universal LNB pointing to 28.2. The correct config is simple, single, 28.2.
As the solo2 has internal loop through, the better hardware setup is: signal wire to Tuner B.
Software set up :-
Tuner B = Simple, single, 28.2
Tuner A = loop through from tuner A.
Note:
You cannot use a Sky Q wideband LNB with Enigma2 receivers.
Welcome to Satellite Support Forum .: Home of OpenViX Team:.!
World-of-Satellite enthusiasts Satellite, IPTV, Technology, Audio visual Forum.
Any information provided on this site is not guaranteed in any way. Some articles may discuss topics that are illegal, so this information is provided for educational purposes only, your use of the content, downloads and files, or any part thereof, is made solely at your own risk and responsibility. Viewing Pay TV without a valid subscription is illegal. !! World-of-Satellite.com cannot be held responsible for the content of any information stored or posted on this forum.