.... it doesn‘t use root and kernel for the usb recovery flash anymore ...
Gigablue Quad 4K & UE 4K
.........FBC Tuners:
------------------> GT-Sat unicable LNB to 1.5M dish(28.2E)
------------------> Gigablue unicable LNB to 80 cm dish(19.2E)
.......................
Vu+ Uno4KSE, Dreambox dm900
AX HD61, Edision Osmio 4K+, Zgemma H9Combo, Octagon SF8008 , gbtrio4k, h9se using unicable ports
Zgemma H9 C/S into Giga4K
Are you pressing the little button under the front flap when you power on?
Instructions say......
https://www.world-of-satellite.com/s...es-H7S-amp-H7CFlashing the Receiver.
1) Power off the receiver
2) Ensure no other USB devices are plugged into the receiver
3) Insert the USB stick containing the ima
possible.
4) Power the receiver on.
5) Immediately after powering on PRESS AND HOLD the front power button behind front flap until flashing
appears on front display.
Last edited by ccs; 23-06-20 at 18:57.
Andy_Hazza (23-06-20)
Thanks everyone for your help. Working perfectly now.
Andy_Hazza (23-06-20)
Can anyone provide any support here. This time i am trying to flash the zgemma h9 twin and i think its th same principle. I insert USB while holding reset button. I see the word flash come up but then it does not activate the flash. I release the button but it goes straight to boot.
Really frustrating
Why don't you flash it using the remote? Which image is on it at the moment? Name and version/date please.
Gigablue Quad 4K & UE 4K
.........FBC Tuners:
------------------> GT-Sat unicable LNB to 1.5M dish(28.2E)
------------------> Gigablue unicable LNB to 80 cm dish(19.2E)
.......................
Vu+ Uno4KSE, Dreambox dm900
AX HD61, Edision Osmio 4K+, Zgemma H9Combo, Octagon SF8008 , gbtrio4k, h9se using unicable ports
Zgemma H9 C/S into Giga4K
Can't log into telnet. Not working
. Just can't figure out how to reflash using USB
Can you not boot into recovery mode and flash from there? Press the power button on remote when you start it up.