There was 2 connected one was disabled when I took the screenshot but I have taken one out and it is still the same
There was 2 connected one was disabled when I took the screenshot but I have taken one out and it is still the same
Setup your scan settings excatly like this
http://www.world-of-satellite.com/sh...l=1#post265115
Do a manual scan
Another thing as well when I try and scan it takes an absolute age but yet doesn't find anything
I though that was what we are tryiong to fix at the moment
Plug your other receiver in this loaction and check you have reception?
If I do an automatic scan whith those settings above it fails to find a transponder and says
ERROR - failed to scan (error starting scanning)
You can't be using same feed, it must be split somewhere. Connecting the other receiver in this location will confirm signal is fine at this point. No point continuing until we know that reception is fine here.
What was the error in ABM please?
It fails saying cannot read data and in the log it says timed out
I'm out of this thread until you confirm the other receiver locks on to a signal in this location. Or you take this receiver to where the other one is and use the cabling that the other one is using.
IMAG0202.jpg
This is the other receiver at the venton location