trying to get hd 800 se to move my dish but no go.
anyone no the settings to get it to work
trying to get hd 800 se to move my dish but no go.
anyone no the settings to get it to work
yes....but you need to know your geo position,....without being exact, where are you based?
Units; VU+Ultimo/duo/DM800/7020HD/tm9100
1.2 channel master/quad feedhorn/36volt /vbox
1 fixed dish, and 1 motorized 1mtr dish
and a pile of redundant cards/cams
found on another forum that there is an option in advanced settings to use USALs, in simple mode once you input your geo setting, USALS is used by default
i had it on advanced all sorted
Last edited by Rob van der Does; 09-06-12 at 06:59. Reason: Corrected 'USALS'
good stuff, just pleased you are sorted
Units; VU+Ultimo/duo/DM800/7020HD/tm9100
1.2 channel master/quad feedhorn/36volt /vbox
1 fixed dish, and 1 motorized 1mtr dish
and a pile of redundant cards/cams
Works on 'advanced' just as well.
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
I couldn't get USALs to work ... had to use diseq 1.2
USALS works fine here on all images I've tested, new and old. Suppose this also depends on setting/bouquets uploaded and motor used.
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
Please help keep OpenViX online, donate HERE.
Rules can be found HERE
Support our sponsor World-Of-Satellite HERE
GIGABLUE UHD QUAD 4K, VU+ DUO 4K SE, ZGEMMA H7S, VU+ UNO 4K SE
Triax 1.1m Powered by TM2600, Fixed 28.2 Zone 2 dish with GT-SAT Unicable
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
which settings do you want to see... Long/lat?
i set it to simple positioner and I had the correct Long/Lat in and the correct north/west part in too. I think it might be the motor that doesn't work with USALS or it's just broke. It works fine when I store positions, so it's not a big problem for me.