Freezing and mosaicing

[canthackit]

Hello

just and ssetup my new 7000 i'm getting terrible freezing and mosaicing some thing i never got with my Duo the is in the bottom slot and on the info its showing as sci, is this correct?

i've really got to get this sorted the channels are unwatchable

regards: canthackit

[pooface]

Hello

just and ssetup my new 7000 i'm getting terrible freezing and mosaicing some thing i never got with my Duo the is in the bottom slot and on the info its showing as sci, is this correct?

i've really got to get this sorted the channels are unwatchable

regards: canthackit

Have you ran all updates? As this was updated with one of the drivers, and should be incorporated in the 2.1.4 iirc...

For interest:

20110117
-vfd settings: control scroll properties and symbols (/proc/stb/lcd/*)
-use pip for second tv only video (/proc/stb/vmpeg/1/external)
-ci support fixes
-cardreader fixes
-fan control (enable/disable fan vcc)

Another thing to try ... use oscam Support to be better for nds white cards

[canthackit]

yes i've done the update mate one of he first things i did.

oscam i find too difficult too daunting.

got the vix 2.1 image on with CCcam 221

regards: canthackit

[Sicilian]

Have you copied your CCcam.cfg from your Duo? Cant remember is which card slot is sci0 & sci1.

Tried scanning 28.2?

[canthackit]

Hello Boss

the on screen info it says sci

on the boxkey it says /dev/sci0

regards: canthackit

[Sicilian]

Did you copy your CCcam.cfg from the Duo?

[canthackit]

yes Boss i did

[Stanman]

If you press blue and entitlements it will show which slot the card is in.
Bottom is 0 and top is 1. You say 7000 but do you mean ET9000?
I used it with VIX and cccam no problems whatsoever.
Also PF to the ET as it will have new IP address.

[Sicilian]

you tried a different card slot changing sci0 to sci1 in the config?

[canthackit]

OOOOOOOOOOpppps

yes i mean the 9000.

just read this from above, i mean the post above not god

/dev/sci0 indicates that you are putting your Sly card in the top slot card reader. /dev/sci1
would be the second slot.

does this apply to the 9000 (got it right this time)

ok card in bottom slot and showing as sci0

regards: canthackit

[Stanman]

Are you sorted now?

[canthackit]

nope mate just been changing slots top slot dont seem to recognise the card at all.

so it's in the bottom slot (sounds painfull dont it) on /sci0

still got really high ecms.

just felt the top of the box it's scrorching, is this how they run as well?

regards: canthackit

[Sicilian]

if you change the card to sci1 and move the card you need to reboot.

[Donnie]

Just to eliminate other factors bud make sure you # out any F or C lines.
And if needed Oscam really aint that bad.

[Stanman]

You haven't got it over clocked?
Compared to my DUO th ET does give slightly higher ECM times but viewing is absolutely fine.