Hardware setup:
Code:
https://www.world-of-satellite.com/showthread.php?18087-Fruitballs-Motorised-Installtion-Guide
Tuner configuartion picture atatched
The way I learnt to do a motorised setup: (1st point repeated to emphasise what not to do)
1. Forget scanning and bouquets
2. Forget scanning and bouquets
3. Forget scanning and bouquets
4. Reset motor. The TM receivers are brilliant at this.
5. Send motor to "0"
6. Install channel list on E2 receiver
7. Configure tuner for USALS
8. Select a service on a chosen satellite. Somewhere near middle of arc
9. Tweak dish assembly to get best signal
10. Select another service on another chosen satellite on western extremity
11. Tweak dish assembly to get best signal
12. Select another service on another chosen satellite on eastern extremity
13. Tweak dish assembly to get best signal
As you dish follows the arc, it should be simple
Tuner configuration picture attached: