Hello,
I currently have a motorised setup with single output LNB connected to my smart tv in built tunner. I have a seperate Linux tuner which i connect if I want to use the motorised option.
I use the tv inbuilt at tunner as its easy for my father to use for watch ng free to air on 28.e as this has more channels than freeview.
I want to upgade my LNB to dual twin output type so i can add a second tv sat tunner in another room, I will not be using that to turn the motor.
I chose the above config to avoid signal conflicts when i was using a sat splitter between the 2 tvs which I then learnt that it causes channel conflict problems.
The question is how do i cable up a dual output LNB?
Do I cable it up the same as the single LNB but use the second LNB out put to connect directly back to my second tv sat tunner?