After trying to add C line, error message pop's up on screen every five minutes. Anyone experiencing same issue please?
Please see image attached. Thank you.
After trying to add C line, error message pop's up on screen every five minutes. Anyone experiencing same issue please?
Please see image attached. Thank you.
Try re-reading the forum rules.
Gigablue Quad 4K & UE 4K
.........FBC Tuners:
------------------> GT-Sat unicable LNB to 1.5M dish(28.2E)
------------------> Gigablue unicable LNB to 80 cm dish(19.2E)
.......................> FBC & DVB-S2X into 90cm dish (27.5W) Opticum robust Unicable LNB
AX HD61, Edision Osmio 4K+, Zgemma H9Combo, Octagon SF8008 , gbtrio4k, h9se using unicable ports
Zgemma H9 C/S into Giga4K
I'm desperately sorry if I offended forum rules, I wasn't clear if my question was guidelines.
Can you kindly advise where I place it please, which folder?
Thank you.
Gigablue Quad 4K & UE 4K
.........FBC Tuners:
------------------> GT-Sat unicable LNB to 1.5M dish(28.2E)
------------------> Gigablue unicable LNB to 80 cm dish(19.2E)
.......................> FBC & DVB-S2X into 90cm dish (27.5W) Opticum robust Unicable LNB
AX HD61, Edision Osmio 4K+, Zgemma H9Combo, Octagon SF8008 , gbtrio4k, h9se using unicable ports
Zgemma H9 C/S into Giga4K
You have probably got the wrong file extension on your CCcam.cfg being used to decode your card.
In windows, there is an option to show file extensions, enable it. You probably have a .txt at end