Hi all,
I decided to set up a dish using 4 Unicable LNB's to try and get 13E, 19.2E, 23.5E, 28.2E but am struggling and only seem to be able to get 28.2E working.....
I am using the Freesat V8 satellite finder and get a strong signal (80%) and quality (85%) on 23.5E. When I then scan for channels on the V8 (connected directly to one of the LNB legacy ports), I get the channels and am able to watch. But when then scanning for channels on my receiver (connected to the Unicale port on the LNB and FBC tuner), I get nothing.
So my first conclusion was that the Unicable port of the LNB must be faulty, so tried another, but same result. Then I swapped out the cable from the working LNB at 28.2E to rule out faulty cabling, but again no channels. I am at a loss what could be the issue here .... I am using below:
Dish: Gibertini OP100
Box: Gigablue UHD Quad 4K
LNB: Maximum Unicable2 DCCS LNB 24-band x 4
Openatv 6.4
Any suggestions/idea's are very much appreciated.....