I have been trying to set up Client Mode on my ET8500. Setup is Server Vu Duo2 > Client ET8500. Boxes are hard wired Gigabit LAN and are both running 5.2.044. I have previously been using RCSC which always worked pretty well but Client Mode seems a neater solution.

I enter the server details and press Green to save, and am given the message that the GUI needs to restart. I was aware that restarting can take some time whilst bouquets etc are transferred and I do have a large channel list. However, the box never restarts properly and seems to be stuck in a loop. I have tried powering off and back on but the same boot loop. I have tried a fresh flash on the ET8500 with the same results.

Looking at the logs directory, a new debug log is being produced every 50 seconds or so.

I wonder if someone could have a look at one of the logs (attached) and see if there is anything obvious?

Enigma2_debug_2019-07-13_19-09-05.log

Many thanks