Screen Sizing after Update

[techygirl]

I updated my ET8500 via Image manager to 5.2.001 but I don't appear to have the display settings correct although I selected the same settings when going through the install (HDMI - 1080p - multi). On previous updates everything goes through fine and I never have any problems.

On some channels, when I go into any of the menus such as guide or settings the display is too big for the screen. I tried reinstalling but with the same result. On investigation the channels affected are - non-HD channels such as BBC1 NE&C, ITV2, Dave, etc. It affects both Freeview and Satellite.

Unfortunately I don't understand enough about the display settings to diagnose what I need to do.
The Video settings are as follows:
HDMI
All Resolutions
no
5 seconds
1080p 24Hz
1080p 24Hz
1080p 24Hz
1080p 25Hz
1080p 30Hz
500
Auto
Auto
yes
yes
0
0

[Andy_Hazza]

What TV have you got? Most TVs have an overscan feature thats enabled which you need to disable/turn off. On my LG TV it is called “Just Scan” in the Display settings. My old Panasonic was called “Overscan”.


Sent from my iPhone using Tapatalk

[Andy_Hazza]

Usually when “All Resolutions” is set to Yes can bugger the picture up.


Sent from my iPhone using Tapatalk

[techygirl]

It is a cheap one - Hitachi 50HB6T72U Smart. I can't see anything in the menus about overscan or similar but will look in the manual tomorrow.

But I have changed the All resolutions to disabled and it appears to have cured it. 👍🏻