hi i have vix image installed and just want to know what
in the positioner menu are
calibrate
and
calculate
and what they does
hi i have vix image installed and just want to know what
in the positioner menu are
calibrate
and
calculate
and what they does
Not needed unless your tv is ancient and does not have the Overscan feature.
Sent from my iPhone using Tapatalk
Vu+ Ultimo 4K with 3TB HDD, Dual FBC (Sat) tuners, 1x Twin Hybrid DVB-C/T/T2 tuner
Vu+ Solo 4K with 1TB HDD, Dual FBC (Sat) tuners, 1x Hybrid DVB-C/T/T2 tuner
Vu+ Solo 2 with 1TB HDD 'White Edition', 2x DVB-S2 tuners
Mut@nt HD2400 with 1TB HDD, 4x DVB-S2 tuners
Fixed 28.2E Technomate 65cm Mesh Satellite Dish with Inverto Unicable II/JESS LNB and Inverto Unicable Splitter
Fixed 28.2E Sky Zone 1 45cm Satellite Dish with Octo LNB
(All receivers installed with the latest Dev build)
@andy is that not like a fine tune on a motorised setup like moving dish slightly for a stronger signal,maybe you are thinking of picture adjusting to fit tv screen?
yea andys reply sounds strange
and i can't see what my motor should have anything to do with overscan
Usually when position gets a mention its to do with picture on screen not fitting.
Yours shows like a fine tuning to get a better signal i am thinking.
vimmers (28-05-18)
Sorry my bad. I was indeed referring to the picture positioner and not the Motorised positioner. Sorry for any confusion.
Sent from my iPhone using Tapatalk
Vu+ Ultimo 4K with 3TB HDD, Dual FBC (Sat) tuners, 1x Twin Hybrid DVB-C/T/T2 tuner
Vu+ Solo 4K with 1TB HDD, Dual FBC (Sat) tuners, 1x Hybrid DVB-C/T/T2 tuner
Vu+ Solo 2 with 1TB HDD 'White Edition', 2x DVB-S2 tuners
Mut@nt HD2400 with 1TB HDD, 4x DVB-S2 tuners
Fixed 28.2E Technomate 65cm Mesh Satellite Dish with Inverto Unicable II/JESS LNB and Inverto Unicable Splitter
Fixed 28.2E Sky Zone 1 45cm Satellite Dish with Octo LNB
(All receivers installed with the latest Dev build)
cactikid (27-05-18)
Calibrate & Calculate are old enigma2 commands that adjust dish position. They are used in Diseqc2 mode (normally with a vBox positioner). They are not really relevant with USALS motors.
The theory is this. Your dish has gone out of position slightly, you adjust one satellite to the correct position, then using the Calibrate & Calculate command (can't remember which) it should automatically adjust all the other satellites settings in the vBox.
I tried using these commands with a vBox, but I found them confusing, and did not work as expected. So I now never use them and use the vBox remote control (which is easier to understand) to do the same operation.