You can find tm600 bootloaders here
http://www.world-of-satellite.com/sh...ot-load-3-1-11
All PM,s asking about c/s on cable will be ignored and reported to forum staff!
Sicilian (20-01-11)
Pooface, do you know of anyway to fix this. Technomate want a receipt, and i cant find it. I have the ebay confirmation from when i bought it ten months ago.
The problem is, it will not even upload the file.
If you paid with paypal you can print of the Transaction Details or a credit-card statement
All PM,s asking about c/s on cable will be ignored and reported to forum staff!
Is there an autodetect to locate the com port. If i go to device manager, i am on com port 4. So i am choosing com port for on the TM control centre 7.1.
I have noticed that i am not getting the "receive Ready from STB" message in the control centre.
You can also check to see if the seller stamped the warranty card that comes with the technomate
All PM,s asking about c/s on cable will be ignored and reported to forum staff!
I had problems with two of these I bought for mates. The first one a image reflash did the job on the 2nd one it would not power up. I opened it up and pushed the power leads inside the box - where the on / off button is and it came back to life and has been fine since.
Support The Sponsor - Buy from the best HERE
Please abide by the rules - have a read HERE
VIX manual & guides >>HERE
Download images from >> HERE
New Box Setup Guide >>HERE
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
PM HELP WILL BE IGNORED PLEASE POST HERE IN FORUM AS IT BENEFITS EVERYONE
Follow us on Twitter
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN! IN OPEN FORUM OR PM
IF THE POSTS HELP PLEASE CLICK THANKS OR ADD TO REP ?
if you connect to your router, and power on while holding the power button, youll get a number, this is for the miniweb to flash
if you press and hold the up (or is it right, one of the 2) button while powering on, youll see nothing in the display, but, manually change your TV to the scart socket that the receiver is connected to, and youll see the uboot menu, to allow you to manually reflash via serial lead, you need to set it to update via serial mode before you can update via the control center
Sicilian (21-01-11)