Hi all, I am having a horrible time of it at the minute. I know what to do and where stuff goes etc, I do seem to be struggling to get an actual cfg file for my exact box but not sure if that matters? Can anyone confirm this/post their cfg file please?
I assume it's only 1.35 that is used and not 1.38 seeing as the latter is not on the vix download page?
Right, the problem, Cccam works fine but glitchy so I did the necessary messing, installed Mgcamd, shut down Cccam and enabled start up, I did everything right, I read and double checked. I did the CWS = thing correctly, kind of not sure where the CWS = keepalive line is meant to go. Anyway, my box gives no tv yet at the other end the guy sees me as connected but at my end.....nothing, swap back to Cccam and all is good again.
So, I have done everything as it should be done *apart* from find an actual cfg for my exact box. I have read and read before posting here.
Does anyone have any help or suggestions please? Obviously the box was bought from WoS
Edit - box is TM-Nano-Se-Combo
Hello Guest, if you are reading this it means you have not registered yet. Please take a second, Click here to register, and in a few simple steps you will be able to enjoy our community and use our OpenViX support section.
