Oscam will not work

[Hamram]

I upgraded from 3.2, and now I have trouble with oscam. I use the same config-files as always, but no action. I have also tried different versions of oscam, and some will not even start. With oscam running, it seems like it cannot find/read the card. Is there anything new in the latest image..? I just don't get it, I have the same files as always, and I have tried with the same oscam as before, plus severeal others, but no luck at all.

In the status log, I can read this:
ERROR opening device /dev/sci1
Cannot open device: /dev/sci1

Any ideas out there..?

[Hamram]

I rolled back to 3.2 037 and everything runs smooth...

[lincsat]

Works OK for me. Have you tried the other reader - /sci0

[Hamram]

Works OK for me. Have you tried the other reader - /sci0

Yes, it was the same on both readers.

Are you using the same configuration files as in earlier image versions?

[abu baniaz]

Someone had an issue recently. They installed the oscam for external card readers.

[Trial]

Hi,
this error is typical if for instance the combination of CCcam and OScam is used. CCcam starts first and blocks the reader. Did you have another softcam installed? I use my config files for over a year now without any changes.

ciao

[Hamram]

I have CCcam as well, but have never before had any problems with this combo. Maybe because I start oscam first..? Anyhow, I did a fresh install just now, and this time it runs just fine.

[Trial]

Hi,
I also used CCcam together with Oscam but they did not work together if the config or start order is wrong. You used solution 1 and the second would be to say CCcam to stay away from the reader.

ciao