VU 4K Cable setup

[romdut]

I have just connected a cable from the NTL box on the wall to the reciever, did a scan for channels and get ' scanning failed' message up not a single channel
in the setup do I need to alter things I have:
Freq , Symbol rate , Modulation , Network ID , Use offical channel numbering , HD List and Enable auto cable scan
Have checked the cable and connectors outside and all ok.
I am in the Teesside area if this helps

[Ashley69]

Use ABM and set your net id for your area.

[romdut]

Use ABM and set your net id for your area.

Thanks - just got that info now waiting for the TV back after the soaps

[romdut]

Just entered the info and still the same - 'scanning failed'
Do i need any addition file(s) and or to change / edit other details

[Ashley69]

Have you had the virgin tv working prior on another box?

[Huevos]

Please post a photo of how you have the cables connected at the back of the receiver.

[romdut]

Just double checked and no signal at all in signal finder , checked cable at both ends so guessing it's been cut outside somewhere. I will be in the garden most of the day so will be looking deeper
will write back 2moro

[Ashley69]

So have you had Cable tv working before? and as Huevos as asked are you connecting to the correct input (rf in- using adaptor)

[romdut]

This is the first time I have used cable , just moved into the property (have the sly setup and running) the rf is connected with cable tuner installed bought from sponsor 2 weeks ago

[romdut]

Please post a photo of how you have the cables connected at the back of the receiver.

Photo of cables at back of boxPhoto0081.jpg

[Ashley69]

I see what you've done. You've put a normal RF in connector on the end of your cable cable. Didn't know you could do it this way. I have always used the cable to Rf adaptors.