I have just brought a solo 2 se and can't seem to set the remote to control the tv.
The guide says to press 1 and 3 simultaneously until the led illuminates but this doesn't happen.
Can anyone advise what I might be doing wrong?
Thanks
I have just brought a solo 2 se and can't seem to set the remote to control the tv.
The guide says to press 1 and 3 simultaneously until the led illuminates but this doesn't happen.
Can anyone advise what I might be doing wrong?
Thanks
mrblack (22-04-16)
Yeah you defo have to press and hold 1 & 3 together till the red led light appears (you are doing this on the Vu+ remote yeah?), then input the tv code (4 digits), then press and hold the mute button till the sound goes off. Then press the +/- volume button and your Vu+ remote should no be controlling your tv. Then press the stop and ok button together to come out of the tv code programmode.
Vu+ Ultimo 4K with 3TB HDD, Dual FBC (Sat) tuners, 1x Twin Hybrid DVB-C/T/T2 tuner
Vu+ Solo 4K with 1TB HDD, Dual FBC (Sat) tuners, 1x Hybrid DVB-C/T/T2 tuner
Vu+ Solo 2 with 1TB HDD 'White Edition', 2x DVB-S2 tuners
Mut@nt HD2400 with 1TB HDD, 4x DVB-S2 tuners
Fixed 28.2E Technomate 65cm Mesh Satellite Dish with Inverto Unicable II/JESS LNB and Inverto Unicable Splitter
Fixed 28.2E Sky Zone 1 45cm Satellite Dish with Octo LNB
(All receivers installed with the latest Dev build)
mrblack (22-04-16)
If you have a Solo2 SE then you have a clone receiver.
The remote most likely wont be an official VU remote, which maybe why it wont function as expected or operate your TV
not if it is a solo se v2. in that case it should work try this http://www.abcom.sk/content/priloha/...t_up_guide.pdf