Thanks Abu, yeah that's how I've got it mate, reflashed to latest image but still no joy, gonna watch the match and get back up the ladder!
Thanks Abu, yeah that's how I've got it mate, reflashed to latest image but still no joy, gonna watch the match and get back up the ladder!
New single cable ran from box to motor only, tried in both ports of both tuners, rebooted each time, still no light on motor.
I would have been convinced the motor was goosed If I didn't get the 25 degree East movement one time (Still don't know how I did It as can't see dish from receiver)
Head done right In
Shameless bump!
Have you tried the receiver on a fixed dish?
Can you post up a screen shot of your tuner settings
Support The Sponsor - Buy from the best HERE
Please abide by the rules - have a read HERE
VIX manual & guides >>HERE
Download images from >> HERE
New Box Setup Guide >>HERE
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
PM HELP WILL BE IGNORED PLEASE POST HERE IN FORUM AS IT BENEFITS EVERYONE
Follow us on Twitter
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN! IN OPEN FORUM OR PM
IF THE POSTS HELP PLEASE CLICK THANKS OR ADD TO REP ?
Huevos I've been running the box about 4 months on a fixed dish with no problems
Stanman please see attached, Simple mode advised by Abu
Tuner settings.jpg
Still no joy, Is it possible that It's the box?
Anybody help?
Double check your co-ordinates. The ones you have places you in the North Sea
Cheers Lads
54.800, -1.672
Shouldn't the motor still be receiving power though even with the incorrect co-ordinates?
Yes, you should get power to the motor. If your tuner was faulty, it would have not worked at all AFAIK. (I'm sure that someone will correct if this is not the case)
With those co-ordinates, you should be inputting West.
Start again.
Retrace the cables, only connect the one that goes to the motor. Triple check the F-plugs. Make a backup of your image and save it. Flash a new image to rule out any config issues and configure as pictures. The tuner that is not connected, set that as not configured.
Upload your settings file to this thread. It will be located in /etc/enigma2/
Test one tuner first.
Last edited by abu baniaz; 04-10-15 at 02:04.