Hello Guest, if you are reading this it means you have not registered yet. Please take a second, Click here to register, and in a few simple steps you will be able to enjoy our community and use our OpenViX support section.
Page 2 of 3 FirstFirst 123 LastLast
Results 16 to 30 of 32

Thread: tuner problem

  1. #16
    Sicilian's Avatar
    Title
    The Boss
    Join Date
    Mar 2010
    Posts
    29,649
    Thanks
    23,585
    Thanked 26,054 Times in 7,638 Posts
    Quote Originally Posted by thor1 View Post
    if both tuners are selected tuner B does not work, if tuner A is turned off tuner B works
    Test the receiver connected to a different dish / LNB.

    Also check your coax/f connectors.
    D I S C L A I M E R

    My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!

    Please help keep OpenViX online, donate HERE.
    Rules can be found
    HERE
    Support our sponsor World-Of-Satellite
    HERE
    GIGABLUE UHD QUAD 4K, VU+ DUO 4K SE, ZGEMMA H7S, VU+ UNO 4K SE
    Triax 1.1m Powered by TM2600, Fixed 28.2 Zone 2 dish with GT-SAT Unicable





  2. #17
    nsw9154's Avatar
    Title
    V.I.P
    Donated Member
    Join Date
    Feb 2014
    Location
    Hartlepool
    Posts
    2,008
    Thanks
    409
    Thanked 458 Times in 373 Posts
    Do you have both tuners set to simple/single/ 28.2E or is one of them set as loop through

  3. #18

    Title
    Senior Member
    Join Date
    Feb 2014
    Posts
    287
    Thanks
    79
    Thanked 24 Times in 19 Posts
    both tuners set to simple/single 28.2E. has said before tuner B will only work if tuner A is switched off, is it worth flashing to build 28 i am using 26

  4. #19
    nsw9154's Avatar
    Title
    V.I.P
    Donated Member
    Join Date
    Feb 2014
    Location
    Hartlepool
    Posts
    2,008
    Thanks
    409
    Thanked 458 Times in 373 Posts
    it's worth a try mate flash to 28 but try it without settings restore just to see if you can get the tuners set up properly as you can always restore your settings later
    just a thought did you do a fresh install of 26 because restoring from Apollo 24 can give a lot of problems

  5. #20

    Title
    Senior Member
    Join Date
    Feb 2014
    Posts
    287
    Thanks
    79
    Thanked 24 Times in 19 Posts
    I only got receiver on Thursday, it came with 26 on but would not let me access ftp and telnet so I reflashed and got them to work

  6. #21
    nsw9154's Avatar
    Title
    V.I.P
    Donated Member
    Join Date
    Feb 2014
    Location
    Hartlepool
    Posts
    2,008
    Thanks
    409
    Thanked 458 Times in 373 Posts
    Ok I understand now well I think it's worth doing a Fresh Flash to Apollo 28 but without settings restore then you can see how every thing is getting set up just to make sure

  7. The Following User Says Thank You to nsw9154 For This Useful Post:

    thor1 (01-09-14)

  8. #22

    Title
    Senior Member
    Join Date
    Feb 2014
    Posts
    287
    Thanks
    79
    Thanked 24 Times in 19 Posts
    I had enough for today I will start again tomorrow, thanks everyone for the input

  9. #23
    nsw9154's Avatar
    Title
    V.I.P
    Donated Member
    Join Date
    Feb 2014
    Location
    Hartlepool
    Posts
    2,008
    Thanks
    409
    Thanked 458 Times in 373 Posts
    no problem mate I am ready for a Pint myself

  10. #24
    Sicilian's Avatar
    Title
    The Boss
    Join Date
    Mar 2010
    Posts
    29,649
    Thanks
    23,585
    Thanked 26,054 Times in 7,638 Posts
    Dont waste your time flashing. Connect it to another dish / lnb as I've suggested. I've seen Sky dish LNB's cause issues like this when they start going wrong.
    D I S C L A I M E R

    My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!

    Please help keep OpenViX online, donate HERE.
    Rules can be found
    HERE
    Support our sponsor World-Of-Satellite
    HERE
    GIGABLUE UHD QUAD 4K, VU+ DUO 4K SE, ZGEMMA H7S, VU+ UNO 4K SE
    Triax 1.1m Powered by TM2600, Fixed 28.2 Zone 2 dish with GT-SAT Unicable





  11. #25
    Rob van der Does's Avatar
    Title
    ViX Beta Tester
    Join Date
    Apr 2010
    Location
    The Netherlands & France
    Posts
    36,262
    Thanks
    1,720
    Thanked 9,461 Times in 6,675 Posts
    The build in satfinder should also help. See if High/Low/Hor/Vert show fine on both tuners.

    Help asked via PM will be ignored.
    The forum is there for help and all will benefit from your questions.
    NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !

    English is not my native tongue.
    I apologise for all my grammar, spelling and idiom errors.

  12. #26

    Title
    Senior Member
    Join Date
    Feb 2014
    Posts
    287
    Thanks
    79
    Thanked 24 Times in 19 Posts
    hi
    took LX3 to a friends who as sky hd tried on his dish same results,reflashed to build 28, both tuners show up in satfinder, signal is in the eighties snr and in the ninties agc

  13. #27
    Sicilian's Avatar
    Title
    The Boss
    Join Date
    Mar 2010
    Posts
    29,649
    Thanks
    23,585
    Thanked 26,054 Times in 7,638 Posts
    Tune to BBC One HD > Press Record, now zap to ITV HD, do you see ITV HD?
    D I S C L A I M E R

    My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!

    Please help keep OpenViX online, donate HERE.
    Rules can be found
    HERE
    Support our sponsor World-Of-Satellite
    HERE
    GIGABLUE UHD QUAD 4K, VU+ DUO 4K SE, ZGEMMA H7S, VU+ UNO 4K SE
    Triax 1.1m Powered by TM2600, Fixed 28.2 Zone 2 dish with GT-SAT Unicable





  14. #28

    Title
    Forum Supporter
    Donated Member
    Join Date
    Jul 2014
    Location
    God Knows
    Posts
    1,694
    Thanks
    582
    Thanked 266 Times in 247 Posts
    Quote Originally Posted by nsw9154 View Post
    how have you got your Recordings set in Recording Settings I have mine set to (preferred tuner for recording) auto that way both tuners are available

    Attachment 36769
    I flashed recently 030 and noticed if I record, other tuner goes blank And can only view certain channels.

    Did what nsw9154 suggested and it seemed to sort the issue out.

  15. #29

    Title
    Forum Supporter
    Donated Member
    Join Date
    Jul 2014
    Location
    God Knows
    Posts
    1,694
    Thanks
    582
    Thanked 266 Times in 247 Posts
    Still have same problem

  16. #30
    Sicilian's Avatar
    Title
    The Boss
    Join Date
    Mar 2010
    Posts
    29,649
    Thanks
    23,585
    Thanked 26,054 Times in 7,638 Posts
    Quote Originally Posted by john doe View Post
    Still have same problem
    What exactly are each of your tuner settings?
    What exactly is your satellite dish setup and how is it wired/connected?
    D I S C L A I M E R

    My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!

    Please help keep OpenViX online, donate HERE.
    Rules can be found
    HERE
    Support our sponsor World-Of-Satellite
    HERE
    GIGABLUE UHD QUAD 4K, VU+ DUO 4K SE, ZGEMMA H7S, VU+ UNO 4K SE
    Triax 1.1m Powered by TM2600, Fixed 28.2 Zone 2 dish with GT-SAT Unicable





Page 2 of 3 FirstFirst 123 LastLast

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
This website uses cookies
We use cookies to store session information to facilitate remembering your login information, to allow you to save website preferences, to personalise content and ads, to provide social media features and to analyse our traffic. We also share information about your use of our site with our social media, advertising and analytics partners.