this worked ok on apollo 23, just installed 24 and sat mgcamd works ok but cant get cable to work. while installing mgcamd 1.35a it doesnt create mg_cfg file at all. what am i doing wrong?
Softcams from the ViX feeds don't contain any config files.
It's up to you to add the correct file for your subscription.
If you have any settings backed up from 023 use them it will install everything you had working on 023 including your softcam config
VU+Duo2 5.2.025
backup was corrupted,couldnt install it.how do i set up mg_cfg file so that it works on cable and sat at the same time?Originally Posted by Alanp
the mg-cfg file and the newcamd.list go into var/keys.but you must put your settings into these files as wont work blank
How do I do that?
Thread closed.
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
Please help keep OpenViX online, donate HERE.
Rules can be found HERE
Support our sponsor World-Of-Satellite HERE
GIGABLUE UHD QUAD 4K, VU+ DUO 4K SE, ZGEMMA H7S, VU+ UNO 4K SE
Triax 1.1m Powered by TM2600, Fixed 28.2 Zone 2 dish with GT-SAT Unicable
Posting Permissions
